Small Work #1. Language: 2-D to 3-D translation.

Steps for 2D to 3D

Materials:

1. Construction paper (red, green, yellow)
2. Hot glue gun and sticks.
3. Cutting tool (X-acto knife or scissors)
4. Mat board

Steps:

1. Draw 4 squares on red construction paper. Each side of the square being 4 inches. Cut out the 4 squares.
2. Get 1 square and glue one edge to the parallel edge. Do this with the other three squares.
3. You should now have 4 tube looking pieces.
4. Get one of the tubes, on one of the flaps sticking out you will push into the tube until it stays like that. Repeat for the other tubes.
5. Get 2 of the tubes and glue the conjoined points together, it should look like a bow tie.
6. Get the other 2 tubes and glue the flap to the tube so that it is rounded.
7. Glue the 2 rounded tubes to the glued intersection of the other tubes.
8. Now get green construction paper and draw 4 leaf shapes with a flat bottom edge.
9. Cut out the 4 leaves.
10. Grab the square edge points of the leaf and glue it together, do that to the other leaves.
11. Glue one leaf to each area where two flower petals meet.
12. Get yellow construction paper and draw 4 rhombuses and each side of the rhombus is 1 inch. Cut them out.
13. Now cut a thin strip of yellow paper that is 4 inches long and then cut it in half to get 2 strips that are 2 inches.
14. Glue 1 rhombus on one tip of the yellow strip and glue another rhombus on the other side of the first one. Repeat to make a second.
15. Glue the yellow stem on one area where the 2 flower petals meet and then repeat.
16. Get the mat board and cut a 4” by 4” square.
17. Glue the paper glower onto the square

Step 1

Step 2

Step 4

Step 4 

Step 5

Step 6

Step 6

Step 6

Step 7

Step 7

Step 8-9

Step 8-9

Step 10

Step 10

Step 10

Step 11

Step 11

Step 12

Step 12

Step 13

Step 13

Step 14

Step 14

Step 15

Step 15

Step 15

Step 16

Step 17